Getting a "How To" to run - InfoPath Dev
in

InfoPath Dev

Getting a "How To" to run

Last post 01-13-2007 10:55 PM by Shiraz Cupala. 2 replies.
Page 1 of 1 (3 items)
Sort Posts: Previous Next

  • 12-13-2006 04:53 PM

    • robv
    • Not Ranked
    • Joined on 12-14-2006
    • USA
    • Posts 1

    Getting a "How To" to run

    Reply Contact
    I downloaded this, tried to open it but I get an error in InfoPath that says it needs to be at a certain directory on Infopath.com to run.

    http://www.infopathdev.com/howto/examples/default.aspx?i=0672a57e920b4771b62b1c22d5bd314d

  • 12-13-2006 08:55 PM In reply to

    Re: Getting a "How To" to run

    Mark as Answer
    Reply Contact
    Hello Robv,
    You cannot open the manifest directly because it was developed on some other machine and you have just copied it. So to open the manifest you should publish it locally or open it in design mode and preview it.

    Hope this helps!
    Shailaja / http://www.ggktech.com

  • 01-13-2007 10:55 PM In reply to

    Re: Getting a "How To" to run

    Mark as Answer
    Reply Contact
    Hi Rob and welcome. To use the HowTo the easiest method is to right-click the manifest.xsf, click "Design" then from inside the designer click Preview. Also from designer you can click save or publish to properly setup the xsn to be opened directly.
    Shiraz Cupala / Microsoft InfoPath MVP
    Qdabra® Software / Streamline data gathering to turn process into knowledge
Page 1 of 1 (3 items)
Copyright © 2003-2019 Qdabra Software. All rights reserved.
View our Terms of Use.