Browser Enabled Form - Problem

Last post 08-19-2010 10:52 PM by nobbsy. 1 replies.

Page 1 of 1 (2 items)
	Sort Posts: Previous Next

08-19-2010 06:13 PM

nobbsy
Joined on 10-15-2008
Posts 25

Browser Enabled Form - Problem

Reply Contact

Hi,
I have developed a browser enabled form in Infopath 2010, but i have made it 2007 browser enabled form. But when i go to publish i still get an error when using it in Sharepoint 2007, with regards to opening it in the browser I have been given some reasons as to why i might be getting the error, but i would like some assistance in addressing each of these possible solutions.

The form template is browser –compatible, but it cannot be browser enabled on the selected site. This may be caused by one of the following reasons:
The server is not running InfoPath Forms Services

The necessary features are not available on the site collection

The policy setting on the server does not all users to browser-enable form templates.

How can I confirm all the conditions above are addresses, so that I can use browser compatible forms.

Any help much appreciated.

Thanks Craig

08-19-2010 10:52 PM In reply to

nobbsy
Joined on 10-15-2008
Posts 25

Re: Browser Enabled Form - Problem

Mark as Not Answer Mark as Answer ...

Reply Contact

An Update:I have gone into central administration and setup InfoPath Forms Services. I am not sure what settings and policies I need to set, other than in the document library I have made sure, "open in Browser" is selected. What else should i be setting. I have searched and reviewed nearly every topic on this and checked and double checked all the settings that everyone has suggested. As a side note, even when i set "Open Forms in Browser" at the SharePoint library level, the form still uses InfoPath to open the form. It rarely tries to open the form in browser, when it does, it errors. very Frustrating. Thanks for your help.

Page 1 of 1 (2 items)

InfoPath Dev