Data Connections

Re: InfoPath 2010 dropping "Site" on Data connections

Pete_Murphy — Wed, 17 Oct 2012 17:32:00 GMT

Saving the template to ....sites/xxxx3011/WorkOrders/InfoPath Forms

Publishing to ....sites/xxxx3011/WorkOrders/Test1

xxxx3011 is the TeamSite

WorkOrders is a subsite

Re: InfoPath 2010 dropping "Site" on Data connections

Hilary Stoupa — Wed, 17 Oct 2012 16:51:06 GMT

Are you publishing to the same site?

Re: InfoPath 2010 dropping "Site" on Data connections

Pete_Murphy — Wed, 17 Oct 2012 16:04:59 GMT

It happens after being published. Tried it with a blank form on a subsite just like before and the data connection was fine until published. then it truncated off the subsite.

Re: InfoPath 2010 dropping "Site" on Data connections

Hilary Stoupa — Wed, 17 Oct 2012 14:59:40 GMT

So the site is ArkutunDagi-eMOCs? And you aren't publishing the form, or anything, just adding the data connection, closing, and re-opening. Can you try with a new blank form (if you haven't already) and see if it reoccurs?

Re: InfoPath 2010 dropping "Site" on Data connections

Pete_Murphy — Wed, 17 Oct 2012 13:13:09 GMT

Hilary,

I have reposted the screen shots. Yes all I am doing is saving the template then re-opening the saved template. I am betting it is a setting on the server side of InfoPath but I cannot get to that part of the company setup.

Re: InfoPath 2010 dropping "Site" on Data connections

Hilary Stoupa — Fri, 12 Oct 2012 21:25:55 GMT

Your screenshots aren't showing - could you attach them under the Options tab?

All you are doing is saving the form, then re-opening the same saved template, correct? I've not run into this before....

InfoPath 2010 dropping "Site" on Data connections

Pete_Murphy — Tue, 09 Oct 2012 18:27:02 GMT

I am creating data connections to SharePoint libraries and to GetUserProfile. I save the form and exit SharePoint designer. when I reopen the form the data connections have lost part of the URL to the sites they were connected to. Browser forms.

below is the original data connection. fine until i closed InfoPath Designer

Below is what the data connection looks like after reopening the file in InfoPath Designer

Original GetUserProfileByName data connection

GetUserProfileByName connection after reopening up infopath designer.

Any ideas on this would be greatly appreciated.