Views

Re: Design Issue.

Greg Collins — Mon, 12 Mar 2007 16:06:49 GMT

If you have a place on the internet where you can post the images, you can then link to them right here in this forum discussion for me to look at. Thanks.

Re: Design Issue.

vijesh — Sat, 10 Mar 2007 07:41:15 GMT

Hi Greg Collins,

Thanks a lot yar.
In our project your advice hepls a lot. I wish to send you the report that i made throgh Infopath and vb.net.
If you wish the same i will send you the screen shots of design mode and the preview mode.
Once again thanks a lot.

Viju

Re: Design Issue.

Greg Collins — Fri, 09 Mar 2007 18:00:12 GMT

The space you refer to will always exist in the designer--it was planned that way so you could click below the table.

However, if you are still seeing this space in the editor, then what I normally do is click in that space, then press the DELETE key a few times to make sure there's no space characters after the caret (cursor), and then press the BACKSPACE key until the caret moves up to the right side of the table. That normall fixes it for me.

Design Issue.

vijesh — Fri, 09 Mar 2007 15:04:45 GMT

Hi,

I am putting a section first, then inside that section i am giving a layout. My problem is i can't able to remove the space after this layout. That means between the section and layout's bottom line, single line space is there.
Please guide me to solve this.

Thanks in advance
Viju