https://www.infopathdev.com:443/forums/41.aspxIf you're not sure where to ask your question, ask it here. If necessary, our moderators will make sure it gets classified in the correct board.enCommunityServer 2007 SP3 (Build: 31118.962)https://www.infopathdev.com:443/forums/thread/84773.aspxTue, 27 Nov 2012 13:30:58 GMT033a2e2d-04e2-4a9d-be01-a4634161eefd:84773ErnestoM0https://www.infopathdev.com:443/forums/thread/84773.aspxhttps://www.infopathdev.com:443/forums/commentrss.aspx?SectionID=41&PostID=84773<p>I don&#39;t think you can do both:&nbsp;(a) limit the user to only enter two digits (whole number) and then (b) store the same value as a decimal in the same field. InfoPath uses two different data types for each.</p><p>You could have a text box where the user enters two digits (20) and a second node in the schema where you convert that (to .20) for use in calculatation. Would that work?</p>https://www.infopathdev.com:443/forums/thread/84738.aspxMon, 26 Nov 2012 18:18:46 GMT033a2e2d-04e2-4a9d-be01-a4634161eefd:84738csigler0https://www.infopathdev.com:443/forums/thread/84738.aspxhttps://www.infopathdev.com:443/forums/commentrss.aspx?SectionID=41&PostID=84738<p>I have looked all over and can&#39;t find a resultion to the following:</p><p>FieldA - users should be able to enter only 2 whole #&#39;s (e.g. 20).&nbsp; The contents are to be displayed and used in other calculations as .20</p><p>If I set the value to percentage, 2 decimal places but then div by 100, I get too many decimal places.</p><p>If I round, it rounds to the next whole number, not the 2 decimal places.</p><p>I have tried to set the value to whole number then create a rule that when field changes to div by 100. That&#39;s doesn&#39;t work.</p><p>I know this is probably something simple, I just am not getting it today.</p><p>Corrie</p>