https://www.infopathdev.com:443/forums/41.aspxIf you're not sure where to ask your question, ask it here. If necessary, our moderators will make sure it gets classified in the correct board.enCommunityServer 2007 SP3 (Build: 31118.962)https://www.infopathdev.com:443/forums/thread/70901.aspxWed, 05 Oct 2011 22:41:40 GMT033a2e2d-04e2-4a9d-be01-a4634161eefd:70901david nelson0https://www.infopathdev.com:443/forums/thread/70901.aspxhttps://www.infopathdev.com:443/forums/commentrss.aspx?SectionID=41&PostID=70901<p>I found the source of&nbsp;problem that was limiting the rows returned from the SharePoint list -- Preview Form.&nbsp; While using Preview Form, only a subset of the List items are returned&nbsp; - abou 10% - when there are several hundred items.&nbsp; Also, I noticed that it returns some rows from the start of the list and from the end of the list.</p> <p>&nbsp;</p>https://www.infopathdev.com:443/forums/thread/70899.aspxWed, 05 Oct 2011 20:30:21 GMT033a2e2d-04e2-4a9d-be01-a4634161eefd:70899david nelson0https://www.infopathdev.com:443/forums/thread/70899.aspxhttps://www.infopathdev.com:443/forums/commentrss.aspx?SectionID=41&PostID=70899<p>Using InfoPath 2007, I have a Repeating Table bound to a SharePoint list with several hundred items.&nbsp; However, the form is only returning 100 of the rows AND it appears to pick rows at the start of the list and at the end of the list.&nbsp; Is there some upper-limit or other configuration of a repeating table that is causing this behavior?&nbsp; I&#39;ve tested this in a very simple browser form - no other controls or conditional formatting, so I know it is not a configuration conflict with another control on the form.</p> <p>Any suggestions would be greatly appreciated...this is critical to an internal effort.&nbsp; Thank you.</p> <p>Correction...the repeating table is only returning 100 rows and they appear to be randomly selected - not completely in sequence.</p> <p>&nbsp;</p>