https://www.infopathdev.com:443/forums/41.aspxIf you're not sure where to ask your question, ask it here. If necessary, our moderators will make sure it gets classified in the correct board.enCommunityServer 2007 SP3 (Build: 31118.962)https://www.infopathdev.com:443/forums/thread/65514.aspxMon, 28 Mar 2011 18:34:20 GMT033a2e2d-04e2-4a9d-be01-a4634161eefd:65514dlcj210https://www.infopathdev.com:443/forums/thread/65514.aspxhttps://www.infopathdev.com:443/forums/commentrss.aspx?SectionID=41&PostID=65514<p>I was wondering if it was possible to do Data Validation against a list of values via the infopath ui instead of setting up a data validation for each value?</p> <p>For example I have a requirement that if a value of field1 is equal to a value on a list of&nbsp;n number&nbsp;of values (1, 2, 3, etc), then field2 is required.</p> <p>What I&#39;ve done is set up data validation conditions on the field2 that looks as follows:<br />IF Field2 is blank AND <br />Field1 is equal to 1 OR<br />IF Field2 is blank AND<br />Field1 is equal to 2<br /><br />Screen Tip: Field2 Required<br />Message: Please enter a value in Field2 </p> <p>This is ok for a few conditions but i have a list of 50 values.&nbsp; There&#39;s got to be a better way then to write 25 conditions (since you&#39;re only limited to 5 lines to compare per conditions) on the field.&nbsp; I added the 25 conditions so that I could get the requirement met, I&#39;m just looking for a better way to do this if I have a similar requirement in the future to save some time.</p>