General

Re: Showing data after klick on checkboxes

Bre Huston — Tue, 09 Dec 2014 05:37:41 GMT

Hello Dalacarelia,

Here is an example that uses the repeating section with a select check box from the data source. In the first section the box is included, and there is a formatting rule on the second to conditionally hide/show the corresponding details for selections made.

If your goal is to bring the data into your main data source you may be better off using something like qRules Insert command with CopyTable in order to copy over the data, and then use similar logic to hide/show or delete entries that are not needed.

Hope that helps!

Bre

Re: Showing data after klick on checkboxes

dalacarelia — Thu, 04 Dec 2014 15:04:16 GMT

Hi there my happines was short , follwow the link http://youtu.be/SZF8AX3cx18 and you can see how i am trying to solve the problem

Re: Showing data after klick on checkboxes

dalacarelia — Thu, 04 Dec 2014 14:01:45 GMT

Hi there my happines was short , follwow the link http://youtu.be/SZF8AX3cx18 and you can see how i am trying to solve the problem

Re: Showing data after klick on checkboxes

dalacarelia — Thu, 04 Dec 2014 10:39:48 GMT

Thank You , i have trying with the wrong place with my rule :) and the hint is from u

Re: Showing data after klick on checkboxes

Bre Huston — Wed, 26 Nov 2014 23:22:10 GMT

Hi dalacarelia,

Thank you for your great video! It makes it very easy to figure out exactly what you are trying to accomplish. You'll want to use a formatting rule on the second table that uses "All occurances" of the value from your first table != value from your second table that matches, then hide the control.

Let me know how it goes!

Bre

Showing data after klick on checkboxes

dalacarelia — Wed, 26 Nov 2014 13:06:01 GMT

Hi iam tyring too make InfoPath to show data i want to see in a table by using a checkbox

see my problem in this you tube clip

https://www.youtube.com/watch?v=q8YqUsVpR6I